OPTIONAL FACTORY EQUIPMENT
EXTERIOR AND DECK
FRP molded electronics mast for sedan hardtop
Paint the boot top in the correct location for a Freedom Lift
(3) Additional dimmer switches, 1 dimmer in fwd cabin, 1 in galley, 1 in guest SR. Salon is standard.
Fusion Marine stereo iPod dock with (4) speakers and remote control
Inverter/charger 2800 watt true sine wave with remote control
Add 110V outlet in the dinette cabin above shelf on the aft bulkhead outboard.
Add 110V outlet at helm on bumpout below switches
Add 110V outlet to aft wall below switch in main salon.
Add a 120VAC outlet in the forward stateroom on the starboard side opposite of the port side outlet above berth by the shelf.
TV to install on handing locker.
Dark hull colors-flag blue
Anti-skid color (fore & side decks, aft cockpit, and recessed area of swim platform)-smoke white
Optional dinette in second cabin converts to double berth
Accord Shades on all opening portsUltraleather upholstery main salon
Additional Vesselview display for Cummins engines
Reverso oil change system
Install in standard location.
Hot and cold transom shower
Fresh water wash down forward
Fresh water wash down aft
Splendide WD2100XC washer/dryer installed in engine room
Single Seagull water purifier on galley cold water plumbed to separate spigot
Install Freedom Lift NOTE: When installing the fluid container for the Freedom Lift, install it outboard of the stbd cockpit hatch. Make sure it is low enough to refill the fluid.
Replace metal genset Racor filter canister with a clear canister.
Add an additional 4D house battery to system
Chain Counter, model AA560.
Ship control head loose.
Remote for 50 AMP cord reelInstall
(4) Hella turbo cabin fans. One on each locker facing head of berth in the master stateroom. Install (1) fan on the outboard, aft side of the locker facing the head of the berth in the guest cabin. Install (1) fan on the aft angled bulkhead, inboard of the vallance, up high, in the guest cabin.
Capstan for windlass
(3) Reading lights. One outboard and aft of stbd settee in corner, one outboard and aft of port settee in corner, the third placed outboard of counter over microwave. Imtra lights, ILPB21713305, Kiel, Chrome, white glass shade, built in dimmer.
Add a second switch fwd cabin to overhead lights located at the end of the overhead cabinets by the outlet on the stbd side.
Wire overhead LED light above galley, only one light, to it's own circuit w/ dimmer switch.
Install a 120VAC GFI outlet in the cockpit by the shower
Solar panel(s) for charging the engine start batteries to offset battery consumption of Mercathode system.
Cherry towel bars on head door leading into companionway.
Cherry towel bar in middle of head door leading into master SR
Chrome towel bar in head to accommodate two hand towels in lieu of towel ring.
Doors to head cabinet to be cherry panel.
Mirror in upper and lower panels of head door to Master SR.
Make the hanging locker port side master longer/taller to hang clothes by removing the top drawer and raising the hanging bar.
Install the standard fire extinguisher in stbd locker on aft bulkhead.
Install key lock under flip up portion of forward berth mattress in Master SR
Upgrade master stateroom mattress to 8" Latex foam. S&S to make aft width 4" wider
Bring hanging locker in guest cabin out to where bureau base currently is to make the locker as deep.
Delete bureau portion.
Install 2 hanging rods, one outboard and one inboard.
Install a bottom in the lockerIncrease depth of shelf outboard of berth to 7" deep for a bookshelf
Piping on Stidd Seats
Upgrade main salon & dinette seat cushions only to Latex foam
Change main salon table to fold out table top in lieu of oval
Power Stidd Seats
Ship double ss drink holder from nav desk loose.
Convert liquor locker to storage box.
Replace short height drawer box with tall sides on the drawer box.
Delete bottle storage divider from bottom of drawer.
Overhead handrail in main salon, no sunroof
Remove shelf from outboard cabinet above counter fwd of sink.
Install Sounddown insulation under the galley hatch.
Upgrade gas strut if necessary to lift hatch.
Install backup fresh water pumpInstall removable step in galley storage area.
Relocate water filter leaving the fwd end of the storage area empty for future installation of a watermaker.
EXTERIOR & DECK
Add Burnewiin rods holds (port and starboard)